Forward and back epiploons of a bent shaft need to be changed at each its removal or at removal of forward or back covers of a bent shaft.

Replacement of a forward epiploon of a bent shaft is carried out in the following order:

– record a bent shaft of the engine from a provorachivaniye;

– turn off bolts of fastening of a quencher of tortional fluctuations and remove a quencher;

Fig. 3.54. Forward and back covers of a bent shaft, oil pallet: 1 – cap of the oil channel; 2 – block of cylinders; 3 – GRM drive cover; 4 – bolt of fastening of a back cover of a bent shaft; 5 – back cover of a bent shaft; 6 – back epiploon of a bent shaft; 7 – laying of the oil pallet; 8 – oil pallet; 9 – stopper of a masloslivny opening; 10 – bolt of fastening of the oil pallet; 11 – forward cover of a bent shaft; 12 – bolt of fastening of a forward cover of a bent shaft; 13 – forward epiploon of a bent shaft

– remove a forward epiploon 13 (see fig. 3.54 ) a bent shaft from a forward cover of the 11th bent shaft by means of the screw-driver;

– clear an opening of a sealing ring in a forward cover of the 11th bent shaft and a neck of a bent shaft;

– install the directing plug of device for installation of an epiploon on a sock of a bent shaft;

– grease working edges of a new forward epiploon with engine oil and install an epiploon on the directing plug;

Fig. 3.55. Installation of a forward epiploon of a bent shaft by means of special adaptation: 1 – adaptation bolt; 2 – adaptation mandrel; 3 – forward cover of a bent shaft

– install a mandrel of 2 (fig. 3.55) of adaptation on the directing plug and press an epiploon in a forward cover 3 bent shafts, tightening a bolt of 1 adaptation.

Replacement of a back epiploon of a bent shaft is carried out in the following order:

– remove the transmission, coupling and a flywheel;

– drill two openings of small diameter in an end face of a back epiploon 6 (see fig. 3.54 ) a bent shaft, screw in them two screws and remove an epiploon, having pulled out it flat-nose pliers for heads of screws;

– clear an epiploon opening in a back cover of the 5th bent shaft and a neck of a bent shaft;

– grease working edges of a new sealing ring with fresh engine oil;

– establish a back epiploon of a bent shaft by means of a mandrel;

– establish a flywheel (see subsection 3.2.10).