You carry out adjustment of the parking brake only after replacement of a cable of the parking brake, a support, brake shoes or brake disks for what:

— record forward wheels, you will hang out a back part of the car and fix it on basic racks;

— remove the top decorative finishing of the lever;

— remove a back part of the central console.

For adjustment of the parking brake of back brakes of drum type make the following:

— completely release the lever of the parking brake;

— squeeze out a brake pedal against the stop then tighten the lever of the emergency brake on four clicks on a ratchet;

— release a lock-nut and tighten an adjusting nut of a cable on one party so that the back wheel on this party was hardly turned manually;

— release the handle of the parking brake and check that the wheel on this party rotates freely;

— tighten a cable regulator lock-nut;

— similarly perform operation of adjustment on the second wheel;

— establish into place a back part of the central console and the top decorative overlay of the lever.

For adjustment of the parking brake of back brakes of disk type make the following:

— completely release the lever of the parking brake;

— weaken a lock-nut and turn off adjusting nuts so that both levers on a support moved to an emphasis. At the same time hold carving parts of cables the screw-driver;

Fig. 12.31. Adjustment of the parking brake on cars with back disk brakes

— tighten adjusting nuts so that levers on a support departed from an emphasis no more than on 1,5 mm ( fig. 12.31 ). At the same time hold carving parts of cables the screw-driver;

— tighten parking a brake and check that back wheels are not turned then release the lever of the parking brake and are convinced that back wheels rotate freely;

— establish into place a back part of the central console and the top decorative overlay of the lever.