VW Passat repair+ 1. Ekspluatatsiiya of the car + 2. Maintenance + 3. Engines + 4. Cooling system + 5. Power supply system + 6. System of ignition + 7. Coupling + 8. Transmission + 9. Drive of forward wheels + 10. Suspension brackets + 11. Steering - 12. Brake system 12.1. Technical characteristics 12.2. General information + 12.3. Maintenance + 12.4. Replacement of front brake shoes 12.5. Replacement of a forward support 12.6. Replacement of a forward brake disk 12.7. Replacement of the brake drum and back brake shoes on brakes of drum type 12.8. Wheel cylinder of the back brake mechanism 12.9. Replacement of brake shoes on back disk brakes 12:10. Replacement of a support of the back brake mechanism 12:11. Pressure regulator 12:12. Main brake cylinder 12:13. Tubes and hoses of the brake system 12:14. Removal of air from a hydraulic actuator of the brake system + 12:15. Anti-blocking system of brakes (ABS) 12:16. Brake pedal 12:17. Lever of the parking brake 12:18. Cables of the parking brake 12:19. Adjustment of the parking brake 12:20. Vacuum amplifier of brakes 12:21. Stoplight switch 12:22. Elimination of noise of brakes + 13. Wheels and tires + 14. Systems of heating, ventilation and conditioning + 15. Electric equipment + 16. Body + 17. Electric circuits |
Repair Volkswagen Passat B3-B4/Passat B3-B4>> Brake system>> Replacement of a forward support
You carry out removal of a forward support in the following order:
you will hang out a forward part of the car and record on basic racks;
remove forward wheels;
press a brake hose;
weaken, without turning off completely, connections of a brake hose to a support;
on a support of VW turn off two bolts of fastening of a support;
on a support of Girling turn off bolts of fastening of the directing fingers, holding the directing finger from a provorachivaniye a wrench (see
fig. 12.5
);
remove front brake shoes;
rotating a support, disconnect it from a brake hose. Muffle a brake hose a stopper;
if necessary turn off a bolt and remove the holder of blocks from a rotary fist.
You carry out dismantling of a support in the following order:
clear a support of dust and dirt;
the air given to the brake cylinder through an opening for connection of a brake hose under low pressure take the piston from a support, having established at the same time instead of brake shoes wooden whetstone
(fig. 12.8)
;
remove a dustproof cover from a flute in the piston and a sealing ring from a flute in an opening of a support
(fig. 12.9)
;
wash out all details in methyl alcohol or pure brake fluid and wipe them;
at assembly of a support use a new sealing ring of the piston and a dustproof cover;
apply on a piston opening in a support and a sealing ring pure brake fluid. Establish a sealing ring in a support opening;
install a dustproof cover on the piston so that the cover the internal diameter entered a piston flute; insert the piston into a support and at the same time insert an external edge of a dustproof cover into a support before its fixing.
You carry out installation of a forward support in the following order:
if the holder of blocks acted, establish him on a rotary fist and fix by bolts the regulated moment;
screw a support on a brake hose;
establish brake shoes;
establish a support on the holder of blocks;
remove air from the brake system;
establish a wheel and lower the car.
|
|