You make removal in the following order:

Fig. 16.23a. Internal finishing of a forward door on early models: 1 – protective water insulating film; 2 – nut; 3 – bracket; 4 – the handle for closing of a door from within; 5 – overlay of the internal door handle; 6 – decorative plate; 7 – decorative panel; 8 – button of blocking of the door lock; 9 – a locking button bracket (it is pressed inside); 10 – clamp of the decorative panel

– turn off and remove the button of blocking of 8 (fig. 16.23a or 16.23b) of the door lock;

– remove the finishing panel;

– remove a decorative plate (fastens on latches cave-in);

Fig. 16.24. Removal of the handle of a window regulator: 1 – slip; corner and =45 (±12) °

– on a door with window regulators with the manual drive, remove a slip in the direction of an arrow from the window regulator handle, unscrew the fixing screw and remove the handle ( fig. 16.24 );

– take the intermediate plug;.

– accurately remove finishing from the internal handle of closing of a door then unscrew two screws of fastening and remove the handle;

Fig. 16.25. Removal of an overlay of the internal handle

– remove an overlay of finishing of the internal handle of opening of a door for what slightly pull the handle on yourself, hook a slip and displace it to a back part of a door ( fig. 16.25 );

– remove a control lever an external mirror;

– unscrew screws of fastening of internal finishing of a door, take internal finishing from a glass consolidation groove, then lift and remove it from a door;

Fig. 16.23b. Internal finishing of a forward door on later models: 1 – cap or high-frequency loudspeaker; 2 – decorative overlay of the internal handle; 3 – handle; 4, 5, 7, 12 – the screw; 6 – decorative slip; 8 – button of blocking of the door lock; 9 – locking button bracket; 10 – bracket; 11 – bracket; 13 – decorative panel; 14 – rubber finishing; 15 – pocket; 16 – loudspeaker lattice; 17 – window regulator handle

– having unscrewed fixing screws, remove a pocket 15 (see fig. 16.23b ) doors;

– if necessary disconnect wires from a loudspeaker;

– for removal of a protective water insulating film take the compressed pins and remove brackets;

– remove remote control of the door lock and disconnect draft of the lock;

– accurately turn off and remove a protective water insulating film from a door.

You carry out installation to the sequences, the return to removal.

Replace the brackets broken at removal.

Check correctness of connection of electric sockets.

At installation of the handle of a window regulator it is necessary to sustain its situation according to fig. 16.24 (the corner "and" has to be equal 45 ° ± 12 °), the window at the same time has to be completely closed.