You make removal of a front bumper in the following order:

– unscrew three screws of fastening of the lower lattice of an air inlet;

– disconnect ledges of fastening and remove a lattice, having lowered it down;

Fig. 16.6. Details of a front bumper: 1 – bumper basis; 2 – arm; 3 – bolt; 4 – sealing washer; 5 – guide; 6 – consolidation; 7 – strut pin; 8 – bumper; 9 – spoiler

– disconnect and remove the pins of 7 (fig. 16.6) of a strut fixing a bumper 8 to an insert of a wheel arch;

– disconnect contact sockets of fog lights;

– turn off bolts of fastening of a bumper, without turning off a bolt of fastening of the engine to a body;

– having shifted forward, remove a bumper.

You carry out installation to the sequences, the return to removal.

Tighten bolts of fastening of a bumper the required moment.

Check work of washers of headlights.

You make removal of a rear bumper in the following order:

– from below unscrew five screws of fastening of a bumper to a body;

– remove a covering of a luggage compartment then turn off four bolts of fastening;

Fig. 16.7. Details of a rear bumper: 1, 2 – bolts; 3 – arm; 4 – bumper basis; 5 – sealing washer; 6 – guide; 7 – bumper; 8 – screw; 9 – an arm (for a body the versatile person)

– remove a bumper of 7 (fig. 16.7) .

You carry out installation to the sequences, the return to removal.

Tighten bolts of fastening of a bumper the required moment.