At removal it will be required to drill bolts of fastening of a steering column (the cut-off bolts) and to lower a column. Work accurately to avoid damage of numerous vpressovanny pins and other details of fastening.

Preparatory activities for removal of the dashboard:

– remove average section of the dashboard;

– remove an overlay of powder of a door in a doorway;

– remove the lever of a cowl and disconnect a cowl cable;

Fig. 16.70. Removal of the lower overlay of a forward rack and doorway: 1 – spring bracket; 2 – collar; 3 – lower overlay of a forward rack and doorway

– remove the lower decorative overlay of a forward rack and a doorway (fig. 16.70) , having unscrewed screws of its fastening and having removed spring brackets;

Fig. 16.71. Ware boxes on which the passive security system at accident is not provided: 1, 3 – screws; 2 – percussion cap; 4 – assembly ledge; 5 – a pin with a bracket

Fig. 16.72. Removal of a nadkolenny partition: 1 – arm; 2 – bolt (moment of an inhaling of 10 N · l); 3 – arm; 4, 8, 11 – a bolt, the moment of an inhaling of 10 N · m; 5, 12 – a face decorative cover; 6 – right nadkolenny partition; 7 – cover; 9 – left nadkolenny partition; 10 – screw

– remove trays for storage of trifles (fig. 16.71) or a nadkolenny partition of 6 and 9 (fig. 16.72) . For removal of a nadkolenny partition remove the left slip, exempt from latches and remove face decorative covers, having turned them at an angle 90 °. Then remove the lower overlay of the forward panel of a niche of a wheel and a doorway;

– prepare the new cut-off bolts for installation of the case of a steering column.

You make removal in the following order:

Fig. 16.73. Removal of a decorative slip: 1 – control panel; 2 – decorative slip; 3 – body

– unscrew screws and push inside the panel 3 (fig. 16.73) of management of a heater and ventilation of a body;

– drill srezny bolts of fastening of a steering column and lower a column;

Fig. 16.74. Removal of the dashboard: 1 – socket of a plait of wires; 2 – connectors with "weight"; 3 – I will corrode conductings of the dashboard on the assembly block

– disconnect plaits of conducting and connection with "weight" under the dashboard. Disconnect sockets of plaits of the dashboard from the assembly block 3 (fig. 16.74) of the relay and safety locks;

Fig. 16.75. Fastening of the dashboard: 1,2 – clamps; 3 – caps; 4 – arm; 5 – adjusting pin.

– unscrew screws on both parties of the dashboard, previously having got caps of 3 (fig. 16.75) . Get clamps 1 and 2 of a wall of an air duct which is behind the dashboard;

Fig. 16.76. Dashboard details: 1 – dashboard basis; 2 – glove box; 3 – central slip; 4 – the central slip, 5 – a side slip

– disconnect and take aside the basic arms 4 connecting the dashboard and a tunnel of a body floor and remove the dashboard (fig. 16.76) .

You carry out installation upside-down. On the cars equipped with a speedometer drive cable it is necessary to insert a cable from the back party of a speedometer. For this purpose temporarily disconnect a speedometer drive cable in a mixing air chamber which is under a cowl.

At installation of the dashboard be convinced of the correct installation of air ducts on the heater case.