When performing shpatlevochny works it is necessary to have the wide flexible plastic or nylon pallet. You make alignment of filling on the damaged site of a body so that to give it the required form and smoothness. As soon as it was succeeded to achieve approximately required contour, stop smoothing down filling the pallet as at too long smoothing down it will begin to harden, stick on the pallet and to roll down. Drawing the subsequent, thinner layer of filling should be carried out after drying of the previous layer and so until the level of filling does not begin to act slightly over the level of the processed site. After filling hardening its surplus needs to be removed with a metal scraper or a file. You carry out further processing, using a set of an emery paper. Begin processing with use of a coarse-grained emery paper and further gradually you pass to fine-grained. The emery paper should be fixed on flat wooden whetstone to achieve the most plain processed surface. On a closing stage of grinding the waterproof emery paper should be moistened with water periodically. It gives to the processed surface special smoothness. The Zashpatlevanny dent has to be surrounded on perimeter with a layer of pure metal. For removal from the processed site of dust and fats wash out it water and wipe with the degreasing solution. A dusting apply a thin film of light soil on the site. It will help to reveal all defects allowed when processing. Level the found defects by means of a new layer of filling and again process a surface an emery paper. Continue this procedure before receiving an ideal surface.

After that the surface is ready to final painting. Aerosol putting paint has to be carried out in the warm, dry, windless atmosphere in the absence of dust. For this purpose it is necessary to moisten half of the working platform with water. When coloring only of one panel, other parts of a body have to be covered from hit of paint on them with the paper attached by an adhesive tape. Before putting primer, shake up capacity, apply primer on a trial surface and achieve that she laid down evenly. Achieve a thick layer of primer drawing several thin layers. Polish the grounded surface a waterproof emery paper. At the same time do not forget to sprinkle the ground area water and to periodically moisten with water an emery paper. Before further coloring dry up the processed site. Drawing a paint coat is carried out by a spray. Thickness of a paint coat is reached by drawing several thin layers. Coloring needs to be begun from the center of the painted area and to move to edges back and forth motions until all painted surface, and also about 20 mm around it are not painted. Remove a protective film and paper in 10–15 min. after drawing the last paint coat. Give the chance to fresh paint to harden within at least two weeks, then by means of an obnovitel of paint or thin abrasive polishing paste even the edges of the painted area to the level of old paint. Polish a surface.