At deep dents of elements of a design of a body first of all try to curve a dent back before the maximum approach to a normal form of a body. Body metal in the place of blow is extended therefore the complete recovery of an initial form is impossible. Alignment of a dent about 3 mm lower than the level of a surrounding surface is considered optimum. If there is an access to dent inside, it is necessary to vystuchat accurately it the hammer with a wooden or plastic head. During this operation it is necessary to press densely to outer side of the tapped surface the wooden whetstone corresponding to it. It is required for depreciation of blows of the hammer and for prevention of a flexure of more extensive area. If the dent is in that area of a body where access from a reverse side is complicated or impossible, then in the deepest points of a dent it is possible to drill several small openings in which to screw up the self-cutting screws then to extend a dent by means of flat-nose pliers for the acting heads of screws.

Remove paint from the damaged area and at distance of 20 mm around it.

The easiest it can be made, using the wire brush or an emery paper got on the circle fixed in the electric drill. After alignment of a dent apply on it a layer of filling, paint and polish.