You make removal in the following order:

– disconnect a "minus" wire from the plug of the rechargeable battery;

– remove a steering wheel.

Early models

Fig. 16.62. Screws (are specified by shooters) fastenings of an overlay of a combination of devices: and — on early models; — on later models

Having unscrewed two screws, remove a decorative overlay of a combination of devices (fig. 16.62) ;

– unscrew screws and remove a combination of devices.

Later models

Remove three lattices of system of ventilation from the driver and in the center;

– remove the rotary switch of lighting;

– remove finishing behind the left side of a steering wheel;

– unscrew four screws — on one behind each lattice of ventilation and one behind finishing — and remove a decorative overlay of a combination of devices ( fig. 16.62 , a);

All models

Fig. 16.63. Two screws (2) fastenings of a cover of a combination of devices to the case and two screws (1) of fastening of a combination of devices assembled

Overnite screws, carefully disconnect a speedometer cable, conducting sockets, if necessary disconnect a vacuum hose from the multipurpose indicator and remove a combination of devices (fig. 16.63) ;

Fig. 16.64. Removal and installation of devices from a combination of devices on cars of an early model range: 1 – index of level of fuel; 2 – speedometer; 3 – tachometer; 4 – pin; 5 – fastening screw

– remove devices on cars of early models, as shown in fig. 16.64 . To remove the index of 1 level of fuel and a tachometer 3 get pins 4. Get the index, having disconnected it from sockets of the case and the printed circuit board. to remove a speedometer 2 unscrew screws of fastening 5;

Fig. 16.65. Removal and installation of devices from a combination of devices on cars of later models: 1 – index of level of fuel and temperature of cooling liquid; 2 – speedometer; 3 – tachometer; 4 – screw

– remove devices on cars of late models, as shown in fig. 16.65 . To remove the index of 1 level of fuel and temperature of cooling liquid or a tachometer 3, it is necessary to take accurately them from sockets of the case and the printed circuit board. To remove a mechanical speedometer unscrew screws 4 and carefully get a speedometer 2 of the case. To remove a speedometer with the electronic counter of the passable way it is necessary to get carefully it from the case and to remove from pins.

Devices can be removed without dismantle of the case of a combination of devices.

Fig. 16.66. Speedometer cable details: 1 – spring case; 2 – cable; 3 – sealant

Connection of a cable of a speedometer is carried out according to fig. 16.66 . The cable is entered into a speedometer from the back party. Fixing of a cable of a speedometer is provided with the spring which is built in in a cable cover.

You carry out installation of a combination of devices to the sequences, the return to removal.