You make removal in the following order:

– open, lift and support a back door in open situation;

– disconnect and remove internal finishing of a back door;

– disconnect an electrical wiring from a back door. Pay attention to an arrangement of wires;

– using a pencil or a felt-tip pen, note position of each hinge of a back door;

– while the assistant supports a back door, disconnect an emphasis from a door, previously having disconnected hinges of a door on each side;

– turn off a bolt of fastening of a back door and remove a door.

You carry out installation to the sequences, the return to removal. Before tightening of bolts of fastening of the hinge of a back door check that the back door was correctly combined with a body.

Fig. 16.19. Adjustment of the buffer of a back door: 1 – coupling; 2 – laying edge; 3 – a six-sided key "on 3 mm"; gap and = 3 mm

If it is necessary to adjust buffers of a back door, accurately remove pins from the lever of a strut of the buffer and remove the buffer. Remove a rubber pillow from the buffer, then, using a six-sided key "on 3 mm" ( fig. 16.19 ), wrap the fastening screw against the stop and adjust the cut coupling 1 to provide a gap of equal 3 mm. The edge 2 laying has to contact with the cut coupling.

Fig. 16.20. Adjustment of the buffer of a back door: 1 – ledges; 2 – breaks; b gap = 10 mm

Remove a clip and make adjustment, as shown in fig. 16.20 .

Collect the buffer and insert a pin.

Smoothly close a back door and having opened it again, softly clamp the buffer.