You make removal in the following order:

– turn on the hatch and put it in inclined position;

– install adaptation, opiry it on edge of the decorative panel of a frame of the hatch;

– give a lifting framework down, to those юр until the first line of a frame of a horizontal framework comes into adaptation groove;

Fig. 15.71. Removal of a cover of the hatch assembled with a lifting framework by means of adaptation 3195: 1 – hatch; 2 – adaptation

– strike blow to adaptation with a palm, in the direction specified by an arrow B (fig. 15.71) and beat out a hatch cover assembled with a lifting framework;

– displace a cover back until adaptation does not rest against the roof edge of a body then remove adaptation;

Fig. 15.72. Push a hatch aperture frame back against the stop into the limiter (it is specified by an arrow)

– push a hatch aperture frame back against the stop into the limiter (fig. 15.72) ;

– unscrew screws of fastening of a cover of the hatch (screws have internal 6-faced vents) and remove the panel from above.