15.13.1. Adjustment  of screenwash

Fig. 15.52. Screen wiper mechanism. At installation of a crank or at adjustment of levers of brushes the electric motor has to be in a starting position: 1, 17 – a nut; 2 – plastic washer; 3 – lock ring; 4 – laying; 5 – cleaner arm; 6 – spring washer; 7 – cleaner shaft; 8 – bolt; 9 – rubber washer; 10 – crank; 11, 13 – draft of turning on of the relay; 12 – cleaner electric motor; 14 – rubber brush; 15 – holder of a brush; 16 – spring bracket; 18 – washer; 19 – brush lever

In fig. 15.52 elements of the mechanism of screenwash are shown. At installation of a crank or at adjustment of levers of brushes the electric motor has to be in state into which there is an engine shaft after switching off of a cleaner and operation of the automatic device.

Fig. 15.53. The crank puts on on a shaft in a starting position of the electric motor. At installation to sustain the size and =5 mm

Fig. 15.54. The correct position of levers of brushes at assembly

In fig. 15.53 the angle of installation of a crank on an electric motor shaft is shown. In fig. 15.54 the correct position of levers of the brushes established on shlitsevy shaft is shown. The specified distances are measured from edge of an overlay of a windshield. The size A (from the passenger) has to be about 50 mm. The size B (from the driver) has to be about 35 mm.