Remove a combination of devices.

Fig. 15.24. Removal of facing of a combination of devices

Accurately raise brackets of a cover of finishing and disconnect facing of a combination of devices ( fig. 15.24 ).

Devices are fixed by brackets or screws. Depending on design, press brackets or unscrew screws, for removal of devices.

Fig. 15.25. Arrangement of screws of fastening of a contact plate of the sensor of Hall

Unscrew screws and remove the multipurpose indicator and Hall's sensor. The sensor is fixed on a back part of a speedometer. The contact plate of the sensor of Hall is fixed by two screws on a speedometer drive cable cover ( fig. 15.25 ).

Fig. 15.26. Arrangement of clamps of the block of the alarm system of pressure of oil

For removal of the block of the alarm system of pressure of oil, remove the analog watch, then release clamps and take the block from the printed circuit board ( fig. 15.26 ).

For removal of the voltage stabilizer, unscrew the screw of fastening and take the block. At installation of the block check that three contacts are come on the place and the screw of fastening is reliably tightened.

Fig. 15.27. Speedometer drive cable connector: 1 – situation "the cable is recorded"; 2 – free situation

Remove a connector of a cable of the drive of a speedometer, turning it counterclockwise before release then extend a cable from a connector ( fig. 15.27 ).

For removal of the printed circuit board remove devices, the multipurpose indicator of the block of the alarm system of pressure of oil and a contact plate.

Squeeze clamps of the case of the socket and accurately take the socket and the printed circuit board.