VW Passat repair


+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. System of ignition
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
+ 10. Suspension brackets
- 11. Steering
   11.1. General information
   11.2. Steering wheel
   + 11.3. Steering column
   11.4. Regulator of provision of height of a steering column
   + 11.5. Replacement of protective covers of steering transfer
   + 11.6. Steering transfer
   11.7. Adjustment of position of steering drafts
   11.8. Replacement of steering drafts
   11.9. Replacement of tips of steering drafts
   + 11:10. Adjustment of a side play of steering transfer
   11:11. Replacement of liquid of the hydraulic amplifier of steering
   + 11:12. Pump of the hydraulic booster of steering
   11:13. Adjustment of a tension of belts of drives of auxiliary units
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits



ed639308




Repair Volkswagen Passat B3-B4/Passat B3-B4>> Steering>> Adjustment of a tension of belts of drives of auxiliary units

Fig. 11.25. Laying of belts of the drive of auxiliary units: the car equipped with air conditioning system: 1 – generator drive pulley; 2 – generator drive belt; 3 – pulley of the drive of the pump of cooling liquid; 4 – belt of the drive of the pump of the hydraulic booster; 5 – pulley of the drive of the pump of the hydraulic booster; 6 – pulley of a bent shaft; 7 – air conditioning system compressor drive belt; 8 – air conditioning system compressor drive pulley


The belt of the drive of auxiliary units is considered correctly tense if its deflection (the lower arrow in fig. 11.25 ) between pulleys of the pump and a bent shaft makes no more than 5 mm. You carry out adjustment of a belt by rotation of an adjusting bolt for what:
– weaken nuts and bolts of fastening of the pump;
– weaken a lock-nut of an adjusting bolt on a pump arm;
– rotate an adjusting bolt and constantly check a belt tension until the belt does not cave in on 5,0 mm when pressing by a thumb on the middle of a belt between pulleys of a bent shaft and the pump;
– tighten a lock-nut of an adjusting bolt;
– tighten nuts and bolts of fastening of the pump.