You make replacement in the following order:

– remove steering transfer in connection with probability of damage of a gear lath and gear wheel of the drive;

– release collars and shift a protective cover on steering draft;

– wipe visible traces of lubricant;

Fig. 11.16. Fastening of steering transfer in a vice

– fix in a vice with soft sponges steering transfer ( fig. 11.16 ) and, rotating a drive gear wheel, move a gear lath to the relevant party;

– establish on the verge of the case of the spherical hinge a key on 32 mm and turn out steering draft;

– clear of old lubricant a carving in an internal part of a gear lath;

Fig. 11.17. Cleaning of a carving in a gear lath with application of a tap of M14x1,5

– the corresponding tap clear a carving (M14x1,5) in a gear lath ( fig. 11.17 );

Fig. 11.18. The place of drawing a drop of the means interfering an otvorachivaniye of steering draft

– apply one drop of means of D-6 interfering an otvorachivaniye of steering draft on the second round of a carving of a gear lath ( fig. 11.18 );

– screw steering draft in a gear lath;

Fig. 11.19. Adjusting extent of the left steering draft

– before installation of the left draft be convinced that the size between a basic end face of the internal hinge and an axis of the spherical hinge of a tip the helmsman of draft is equal to 395 mm ( fig. 11.19 );

– grease a gear lath with lubricant like AOF 063 000 04;

– establish a protective cover on steering transfer and fix by collars.