You make removal of the stabilizer in the following order:

– you will hang out and record a forward part of the car on basic racks;

– establish a jack under the central part of a cross beam and lift a jack so that the weight of a beam was perceived by a jack;

– turn off fastening of a suspension bracket of the stabilizer of cross resistance to a cross beam and a body. The forward bolt also fixes a back saylentblok of the cross lever;

– turn off a nut of a connector of the stabilizer and disconnect the stabilizer of cross stability from the cross lever of a suspension bracket. Plates from sheet metal with a rubber support are installed from two parties of the cross lever. At installation it is necessary to establish details on the places. The conic parties of saylentblok are located from plates from sheet metal while the unbent edge of plates is sent to the party, opposite to saylentblok;

– lower the stabilizer of cross stability and take it from under the car;

– check a condition of the stabilizer of cross stability and if necessary replace it;

– in case of wear or strong deformation replace plugs of fastening of the stabilizer to a body.

You carry out installation of the stabilizer to the sequences, the return to removal.

Tighten nuts of fastening of the stabilizer in situation "the car on wheels".