Arrangement of sensors of temperature of cooling liquid:

on SOHC engines the sensor is installed in a final branch pipe of cooling liquid, on the left side of a head of the block of cylinders;

on PB, PF engines and 2E the sensor is installed on a connecting branch pipe;

on RP engines from a reverse side of a connecting branch pipe;

Fig. 4.7. DOHC engine cooling system pump: 1 – bolt; 2 – generator arm; 3 – pulley; 4 – bolt; 5 – cooling system pump; 6 – sealing ring; 7 – top hose of a radiator; 8 – connector; 9 – a hose from a heater; 10 – a hose to a heater; 11 – a hose to a broad tank; 12 – sensor of temperature of cooling liquid; 13 – sealing ring; 14 – pipe; 15 – oil heat exchanger; 16 – lower hose of a radiator; 17 – laying; 18 – thermostat

on DOHC engines the sensor is installed in a final branch pipe (see fig. 4.7 ), on a back surface of a head of the block of cylinders;

on all models electric socket of the sensor of black color.

Carry out removal and installation of the sensor of temperature of cooling liquid in the following order:

– partially merge cooling liquid from the cooling system;

disconnect a wire from the negative plug of the rechargeable battery;

– remove the electric plug;

– remove the fixing bracket and get the sensor of temperature of cooling liquid from a branch pipe;

– take a sealing ring of round section from a branch pipe;

– at assembly establish a new sealing ring.

You make installation of the removed elements in the sequence, the return to removal.